Trusted Wall Insulation for Las Vegas Homeowners
Wall insulation in Las Vegas has a specific job: it slows the heat that soaks into west- and south-facing block walls from about May through September, and it keeps an interior wall from being the coldest or hottest surface in a room. We’re Envelope Insulation Co. Our technicians have up to 10 years of experience, and we install injection foam, drill-and-fill, and exterior wall assemblies across the Las Vegas valley. What sets us apart is the order of operations. We seal first, then insulate, and we publish before-and-after blower-door numbers so you can see the air-sealing result in a single figure. Call us at (833) 362-4859 to start a free estimate.
What Our Wall Insulation Service Includes
Injection Foam Wall Insulation
Injection foam fills the cavity of a finished wall with a slow-rising, two-part foam injected through small, drilled penetrations. You get the cavity filled without tearing off drywall or stucco, which is the whole reason it exists. We use it most in Las Vegas when a stucco or drywall wall over CMU block or wood framing is empty but the homeowner wants it insulated without major surgery; it’s also the fix for a wall panel that sweats on the AC side. We choose the foam density for the cavity and the wall assembly so it cures flat instead of bowing the wall board. Every hole gets patched and photographed as part of your Documented Photo Record.
Drill & Fill Wall Insulation
Drill-and-fill is the classic retrofit method: we drill through the exterior or interior surface at each stud bay, blow loose fiberglass or cellulose into the cavity, and cap the holes. It’s the right approach when an existing cavity is open enough to take loose fill and the wall is wood-framed. On Las Vegas block homes, drill-and-fill with fiber has to be matched to a wall that already has furring and drywall rather than solid block; on solid block there’s no cavity to fill, and that’s where injection foam or exterior rigid board makes more sense. We tell you which method applies to your wall before you commit. Our crews use the same fill-rate and density controls on every bay, and you get the counts.
Exterior Wall Insulation
Exterior insulation means adding rigid board on the outside of the wall, under the new stucco or siding, to break the thermal bridge that block and studs create. This is the upgrade for a wall that’s already full but still hot to the touch on a July afternoon, and for older Las Vegas homes where the block goes solid to the interior skin. We set the thickness and the install detailing so the board covers the framing rather than just the field, because a 2-inch board with a 6-inch gap at every stud does less than you paid for. Exterior work also gives us the chance to re-flash and re-seal penetrations while the wall is open, which is where a lot of the air loss hides. We use Owens Corning and Johns Manville rigid products where the assembly calls for them.
Interior Wall Soundproofing
Interior soundproofing targets the walls between bedrooms, a home office, a media room, or a shared wall with a neighbor. The work is a combination of dense insulation in the cavity plus the detailing that actually stops sound transfer, since fiber alone won’t fix a flanking path at the outlets or the top plate. We use Rockwool in these walls because its density and friction fit handle mid- and low-frequency noise better than fluffed fiberglass. If you’re hearing a neighbor’s TV through a party wall in a townhouse, we’ll tell you whether soundproofing the cavity is worth it or whether the flanking path is the bigger problem. That diagnosis happens before we quote.
Brands We Work With for Wall Insulation

Our cavity products come from Owens Corning, Johns Manville, Knauf, and Rockwool, and we know where each one performs best in a desert-wall assembly. Owens Corning fiberglass batts and loose fill are our standard for framed interior walls, and we size the R-value to the wall depth rather than cramming a thicker batt into a shallow bay. Johns Manville rigid board is what we reach for on exterior work where the stucco is coming off anyway, because its facer holds up to the Las Vegas sun during a multi-day install. Rockwool goes into interior soundproofing walls for the density reason above, and we’ll tell you when the budget doesn’t support it.
Knauf products come into play on some cavity fills where its formulation suits the wall and the blowing equipment we’re running that day. Which product lands in your wall depends on the assembly, the cavity depth, and the fire and moisture detailing; it does not depend on what we happen to have sitting around. Whether your wall was originally built with Owens Corning, Johns Manville, Knauf, Rockwool, or none of the above, we can help you sort out the right fill for it.
Signs You Need Wall Insulation Right Now
Most Las Vegas homeowners call us about one of these five things. If two or more sound familiar, it’s worth a look.
- A west or south wall that’s hot to the touch in the afternoon. If your interior wall surface runs noticeably warmer than the room air on a July day, the wall is short on insulation or the sun is driving straight through it. That heat load shows up on your electric bill and in how long the AC runs to hold a setpoint.
- Rooms that never quite match the thermostat. If the primary bedroom or a west-facing office stays 3 to 5 degrees warmer than the rest of the house, the wall and the air leakage behind it are usually the cause. Re-checking the thermostat won’t fix it.
- A room that’s cold on a winter morning. The same wall that’s hot in summer is the cold one in January. A surface that reads much colder than the room means the cavity is empty or under-filled.
- Noise carrying between rooms or through a party wall. Hearing a TV, conversation, or a neighbor’s bass through a wall signals a hollow cavity and open flanking paths. This is the case where interior soundproofing pays off.
- Visible stucco cracking or a wall that’s been re-stuccoed. A wall that’s been patched or re-surfaced may hide an empty cavity behind it. If you’re already planning stucco work, that’s the cheapest moment to add exterior insulation.
Our Wall Insulation Process – Step by Step

- 1
Written price and written scope before any work starts. Under Haven Standard Clause 1, you get a flat price, a written scope, and a written warranty before anyone lifts a tool. No number gets filled in after the job starts. You can also bring us a competing estimate for a free second opinion, and we’ll read it with you line by line.
- 2
Diagnostics first. We run a blower-door test, a pressurization reading that shows in one number how much air your building envelope is losing, plus a thermal scan of the suspect walls. That tells us whether the problem is missing insulation, air leakage, or both, so the fix goes in the right place. The reading before work is your baseline.
- 3
Air sealing before insulation. We seal the top plates and any penetrations in the wall assembly before a single bag of fill goes in. Blowing insulation into an unsealed cavity is wasted money, because the air still moves through it. This ordering is a hard prerequisite for us, not an upsell.
- 4
Install the wall insulation. Based on the diagnostic, we inject foam, drill and fill, add exterior rigid board, or soundproof an interior wall as specified in the written scope. You get a Documented Photo Record of the penetrations, the fill, and the final patches, included on every visit.
- 5
Verify and record. We re-run the blower-door test after the work and publish the before-and-after numbers, so you can see the air-sealing result in a single figure. Then we walk you through the record and hand over the written warranty, backed by our 365-Day Done Right Promise.
How Much Does Wall Insulation Cost in Las Vegas?
Wall insulation cost depends on which method your wall needs and how much wall you’re treating. These are the ranges we quote most often in the Las Vegas market:
| Service | Typical Cost Range | What Drives It |
|---|---|---|
| Injection foam wall insulation | $1,800 – $4,500 | Wall square footage, foam density, number of holes to patch |
| Drill & fill wall insulation | $900 – $2,400 | Number of bays, interior vs. exterior drilling, access |
| Exterior wall insulation (rigid board under new stucco) | $2,500 – $7,000 | Board thickness, wall area, whether stucco is already coming off |
| Interior wall soundproofing | $600 – $2,000 | Wall length, outlet and flanking detailing, Rockwool vs. fiber |
| Blower-door test (before & after) | Included in qualifying jobs | We include it when the job qualifies so you get the numbers |
A few things move the price. A second-story wall adds access scaffolding. A wall with existing fire-blocking takes longer to work around. The number of electrical penetrations and outlets affects the sealing and patching time. What doesn’t change: you get a flat, written price and a written scope before work starts, and a documented photo record when we finish. Call (833) 362-4859 for an exact number. Estimates are free, and the second opinion on a competing estimate is free too.
Wall Insulation Near Las Vegas – Our Service Area

We install wall insulation throughout Las Vegas and the surrounding valley, including Summerlin, Spring Valley, Winchester, North Las Vegas, Paradise, Sunrise Manor, Whitney, Enterprise, Henderson, Boulder City, and Sandy Valley. Most estimates get scheduled within a few days, and the drive time from the metro core to Summerlin or Henderson is short enough that we can hold a normal appointment window. If you’re in one of these areas and want a wall insulated, the first step is the written price, and you can reach us at (833) 362-4859. For a neighborhood-specific look, see our pages on wall insulation in Summerlin and wall insulation in Spring Valley.
Serving Las Vegas, NV – Our Local Coverage Area
We serve Las Vegas and nearby communities. Use the map below to see the area we cover. If you’re nearby, we can almost certainly help.
Frequently Asked Questions – Wall Insulation in Las Vegas

Wall insulation is material installed inside or outside a wall cavity to slow heat transfer through that wall. In Las Vegas, it’s what keeps a west-facing block wall from turning a bedroom into an oven in July and what keeps an interior wall from carrying sound between rooms. The material is one part; sealing the air paths is the other. We do both, and we record the before-and-after blower-door numbers so you can see the change.
Most wall insulation jobs on a typical Las Vegas home take one to two days, depending on the method. Injection foam and drill-and-fill for a few rooms often finish in a single day, while a full exterior rigid-board install on a large wall may run two days or more. Your written scope includes a time estimate before we start, so you know what to expect.
Most wall insulation projects in Las Vegas run between $900 and $4,500, depending on method and wall area. Injection foam is at the higher end because of the material and patching; drill-and-fill and interior soundproofing are typically lower. Exterior rigid board on a large wall can run higher. You get a written price before any work starts. Call (833) 362-4859 for an exact quote; estimates are free.
Yes. We install Owens Corning and Johns Manville fiber products, Knauf on select cavity fills, and Rockwool in interior soundproofing walls. We’ll recommend the product that fits your wall assembly rather than the one that’s easiest for us. Whether your wall was built with one of these or none of them, we can help you sort out the right fill.
We answer calls 24/7, and a live person picks up rather than a voicemail loop. Wall insulation is rarely a true emergency, but if a wall has been opened by water damage or a project needs insulation finished before a deadline, call us and we’ll tell you the soonest we can get a technician out. Normal appointments for Las Vegas homes are typically scheduled within a few days.
Every wall insulation job gets a written warranty before work starts, backed by our 365-Day Done Right Promise. If something isn’t done right, we make it right. Under Haven Standard: Have it in writing, the warranty is delivered with your written scope, not promised verbally. You also get the Documented Photo Record from your visit as part of the handoff.
Clear access to the walls being worked on and move breakable items away from those walls. For interior soundproofing, empty the rooms on both sides. For injection foam and drill-and-fill, expect a small amount of dust during patching, so cover anything sensitive nearby. We’ll confirm the specific prep for your job when we schedule, and if you’re having a home energy audit done first, that gets scheduled ahead of the insulation.
Schedule Your Wall Insulation Service in Las Vegas Today
If your wall is hot in summer, cold in winter, or hollow-sounding when you knock, we’ll diagnose it and quote a flat, written price before any work starts. We answer calls 24/7, and every estimate is free, with a free second opinion on any competing estimate you bring us. Call (833) 362-4859 to get your wall insulation scheduled in Las Vegas.
Related Services

If you’re exploring the wall assembly, you may also want to look at our wall insulation service, our attic insulation work, our crawl space encapsulation and vapor barrier service, our spray foam insulation, and our blown-in insulation. They’re often quoted together when the blower-door test shows a whole-house envelope issue.
Written by the team at Envelope Insulation Co.