A Topside company - serving Las Vegas, NV

Blown-In Attic Insulation in Las Vegas, NV

Blown-In Attic Insulation in Las Vegas, NV

Blown-in attic insulation in Las Vegas typically costs between $1,400 and $3,400 for a standard single-story home, and the work is usually completed in a single day. It’s the most common way to bring an under-insulated Las Vegas attic up to a modern R-value, and it’s the right choice for most homes built before 2015 that have settled fiberglass batts or thin, patchy coverage. We’re Envelope Insulation Co., and we install blown-in insulation across the Las Vegas valley – from Summerlin and Spring Valley to Henderson, North Las Vegas, and Centennial Hills. Call (833) 362-4859 and a live person answers, day or night.

Here’s the part that separates a good blown-in job from a bad one: insulation only performs when the attic floor beneath it is sealed. Las Vegas attics routinely hit 150°F in July, and any gap around a top plate, can light, or plumbing penetration pulls that heat straight into your living space – no matter how much insulation sits on top of it. That’s why we seal first, then blow. You can read more about the full scope of attic work on our Attic Insulation in Las Vegas page, or keep reading here for the specifics of blown-in.

Key Takeaways

  • Blown-in insulation fills the irregular gaps and settled areas that batts miss – especially over older Las Vegas attic framing.
  • We seal the attic floor before blowing a single bag, and we publish the before-and-after blower-door numbers so you can see what changed.
  • Most jobs are one day, priced in writing before anyone starts, with a documented photo record when we leave.

When You Need Blown-In Attic Insulation

Most Las Vegas homeowners call us after a summer power bill jumps and the upstairs rooms won’t stay cool, no matter where they set the thermostat. Those are the two loudest signals. But there are quieter ones too. Here’s what we look for, and what you can check yourself:

  • The insulation in your attic is below your knee. In Las Vegas, a well-insulated attic floor runs roughly 13 to 16 inches deep. If you can see the tops of the ceiling joists from the access hatch, you’re likely sitting at R-11 or R-19 when your home wants R-38 to R-49.
  • You’ve had batts installed before, and they’ve compressed or fallen. Standard fiberglass batts sag and pull away from the framing over time. In homes built between 2015 and 2025, we often find batts installed in a rush around recessed lights, leaving gaps that blow-in insulation can fill properly.
  • Your upstairs runs 5 to 8 degrees warmer than downstairs in June, July, and August. That gap usually points to heat entering through an under-insulated, unsealed attic floor, not a failing AC unit.
  • You see dust streaks or daylight in the attic. Streaks on the insulation surface are a visual sign of air moving through gaps – the same gaps that need sealing before any insulation goes down.
  • You’re in a Summerlin or Green Valley home built in the 1990s or early 2000s. These communities have a lot of homes with original insulation now sitting at half its rated depth after two decades of settling.
  • A home energy audit flagged low R-value or high air leakage. If a report showed a blower-door reading above roughly 3,000 CFM50, the attic floor is almost always part of the reason.

If two or more of these sound familiar, a licensed installer can confirm it in about 30 minutes with a moisture meter, an R-value probe, and a visual walk of the attic floor.

Our Blown-In Attic Insulation Process

Professional performing attic insulation installation with loose-fill blowing machine
Our Blown-In Attic Insulation Process

The steps below are ours, start to finish. We don’t skip the sealing – not for a fast job, not to save a few hours, not on the smallest attic. Sealed first, then insulated, in that order, every time.

  1. Free attic inspection and written price. We measure the existing depth, photograph the attic floor, and write out a flat price with a written scope and written warranty before any work starts. You get the price in writing, and a free second opinion if you’ve received a competing estimate.
  2. Air sealing the attic floor. Top plates, plumbing and electrical penetrations, can lights, and top-of-wall gaps get sealed with expanding foam and specialty caulk. We install sealed enclosures around recessed lights so insulation can go right over them safely. This is the step most blown-in jobs skip, and it’s the one that determines how much of the insulation’s R-value you actually get.
  3. Blower-door test – before reading. A blower-door test is a pressurization reading that tells us, in one number, how much air your building envelope is losing. We record the “before” figure – and where sealing follows, we record the “after” so you can see the change in CFM50 side by side.
  4. Blowing insulation to target R-value. We install blown-in fiberglass or cellulose to the R-value we agreed on in writing – typically R-38 to R-49 for Las Vegas. We source materials from Owens Corning, Johns Manville, Knauf, or GreenFiber depending on the attic and the target depth, and we measure depth in several spots before we stop.
  5. Baffling and clearance check. Before a single bag goes in, vents and soffits get baffled so insulation doesn’t block attic ventilation, and clearance around any heat-producing fixture is verified. Improper venting is one of the stealth causes of attic moisture problems in Las Vegas, and it’s easy to prevent.
  6. Documented photo record and final walkthrough. We photograph the sealed floor, the installed depth, the baffling, and the blower-door figures if the test was part of your scope. That packet is yours to keep, and it’s included on every visit – not on request.

Every job is covered by our 365-Day Done Right Promise – if it isn’t done right, we make it right. That promise, the written price, and the written warranty together are what Haven Standard Clause 1 (Have it in writing) is built on. No work starts until all three are in your hands.

If you’d like to see how all of our building-envelope work fits together, the home page lays out the full service line – attic insulation, spray foam, radiant barrier, crawl space encapsulation, and full home energy audits.

Blown-In Attic Insulation Pricing in Las Vegas

Most blown-in attic insulation jobs in Las Vegas run between $1,400 and $3,400, and the same-day-to-one-day timeline is typical for a standard single-story home. Here’s a breakdown of the ranges we see, so you can compare apples to apples when you get other estimates:

Service Typical Las Vegas range Notes
Blown-in insulation only (R-38 to R-49) $1,400 – $2,600 For a home with 900-1,800 sq ft of attic floor
Attic air sealing (top plates, can lights, penetrations) $600 – $1,200 Usually bundled with blown-in; priced separately in the written scope
Blown-in plus air sealing, bundled $1,900 – $3,400 The bundle we recommend; most common scope
Blower-door test (before and after) $300 – $500 Included when it’s part of your scope
Insulation removal (if old insulation is damaged or contaminated) $900 – $2,200 Needed for rodent contamination or soaked insulation

What moves the price up or down? Four things matter most: attic square footage, the R-value you’re targeting, whether the existing attic floor is accessible (low-clearance attics take longer), and whether you need removal before install. Homes in Henderson and Green Valley with low-pitch roofs sometimes need more time for access, and homes in North Las Vegas with older framing occasionally need extra sealing around top plates. We price all of it in writing before we lift a tool, so there are no mid-job surprises.

One thing we won’t do: quote a fast close on blown-in insulation only and then skip the air sealing. If a competing bid skips the sealing, we’ll read through it with you at no charge – it’s part of our free second opinion on any written estimate. We’d rather you understand what you’re buying than get the job.

We serve Las Vegas and the surrounding valley, including Henderson, North Las Vegas, Summerlin, Centennial Hills, Spring Valley, and Enterprise. We source insulation from Owens Corning, Johns Manville, Knauf, and GreenFiber, with no proprietary lock-in – so the material we install is the right material for your attic, not the one we’re contractually obligated to move.

FAQs – Blown-In Attic Insulation

professional attic insulation service
FAQs – Blown-In Attic Insulation

How much does blown-in attic insulation cost in Las Vegas?

Blown-in attic insulation in Las Vegas usually runs $1,400 to $3,400 for a typical single-story home, with the most common bundled scope – blown-in plus air sealing – sitting around $1,900 to $3,400. Your exact price depends on attic square footage, target R-value, and whether removal is needed. We put a flat written price on the page before any work starts. Call (833) 362-4859 for a free estimate.

Do I need air sealing before blown-in insulation goes in?

Yes – in almost every Las Vegas attic we inspect, air sealing is required before insulation performs to its rated R-value. Blowing insulation over an unsealed attic floor traps heat that’s still moving through gaps around top plates, can lights, and penetrations. We seal first, then blow, and we measure the change with a blower-door test so you can see the CFM50 before and after. Call (833) 362-4859 to book an inspection.

How long does blown-in attic insulation take?

Most blown-in attic insulation jobs in Las Vegas are completed in one day. A standard home without removal typically takes 4 to 7 hours from start to final walkthrough, and the day includes sealing, baffling, blowing, and the documented photo record. If your job needs insulation removal first, it can run into a second day. Call (833) 362-4859 to schedule a walkthrough.

How deep should blown-in insulation be in a Las Vegas attic?

Blown-in insulation should be installed to an R-value target of R-38 to R-49 in Las Vegas, which usually means 13 to 16 inches of blown fiberglass or cellulose on the attic floor. The exact depth depends on the material. We measure depth in several spots before we stop so the coverage is uniform, not just deep in the middle and thin near the eaves. Call (833) 362-4859 to get an R-value recommendation for your specific attic.

If your attic is under-insulated, or your summer bills are telling you it is, the practical next step is a free attic inspection and a written price. Reach us at (833) 362-4859 – calls are answered by a live person, background-checked technicians arrive in uniform, and no work starts until you have a flat price, a written scope, and a written warranty in hand. A documented photo record and our 365-Day Done Right Promise come with every job.

Written by the team at Envelope Insulation Las Vegas, serving Las Vegas.

Need Insulation help in Las Vegas? Licensed & insured · 30-60 min response · free estimates
Call (833) 362-4859
Local Service Coverage

Request a Free Estimate in Las Vegas

Tell us what you need - Envelope Insulation Las Vegas responds fast. No obligation.

By submitting this form you agree to our Privacy Policy and consent to be contacted by phone, email or SMS about your request, including by local professionals who may handle it.

Prefer to text? Text Us
Call Now - 24/7 Dispatch