A Topside company - serving Las Vegas, NV
R

Reflectix Attic Insulation in Las Vegas, NV

Reflectix Attic Insulation in Las Vegas: What to Know First

Reflectix attic insulation work in Las Vegas usually takes one to two days: a diagnostic visit, a blower-door reading, air sealing where the reflective product is being used as part of the envelope, and then new blown-in or batt insulation to bring the attic floor up to current R-value targets for our climate. Pricing for most single-family jobs runs between $2,400 and $6,800 depending on square footage, existing insulation condition, and whether removal is required. As an independent Reflectix service provider, Envelope Insulation Co. is not affiliated with or authorized by Reflectix; we install and work alongside their products, and we publish the numbers on every job. Call (833) 362-4859 for a written price before any work starts.

Call (833) 362-4859

This page is for Las Vegas homeowners who already have Reflectix radiant barrier or reflective insulation in the attic and now need actual thermal insulation to finish the job, or who need the reflective product removed because it’s trapping moisture, has failed at the seams, or was installed in a way that doesn’t hold up in Southern Nevada heat. We’ll cover how the product fails here specifically, what we do about it, and what it costs.

How Reflectix Products Fail – and How We Fix Them

Reflectix products are reflective barriers, not thermal insulation. They work by reflecting radiant heat, and in a Las Vegas attic that hits 150°F or more on a July afternoon, the failure modes are predictable. Here’s what our technicians see most often, and what we do about each.

  • Reflectix Double Reflective Foil Insulation stapled to the underside of rafters develops pinhole tears and seam separation after a few summers. Staples pull through the foil as truss lumber dries and shrinks in low humidity. Once the reflective surface has gaps, it stops reflecting in those zones. We re-tension or replace the run, and tape seams with a foil-rated acrylic adhesive tape, not duct tape, which fails at attic temperatures in about two summers.
  • Reflectix R-21 Radiant Barrier stapled to the attic floor over old insulation traps heat against the existing batts instead of reflecting it away. When the reflective layer is on the wrong side of the assembly, the foil radiates heat back down into the insulation below. This is the most common installation error we find. We remove the foil from the floor, inspect what’s underneath, and rebuild the assembly with the radiant layer on the correct face and proper air space above the insulation.
  • Reflectix Insulation Roll laid between joists compresses flat within a season because it’s not designed to carry any load, and in Las Vegas, dust infiltration settles on the foil and dulls the reflective surface. We measure the foil’s R-value contribution honestly (a reflective barrier is not a substitute for mass insulation) and top up with blown-in fiberglass or cellulose to a combined assembly that actually performs.
  • Reflectix Radiant Barrier under tile roofing in Las Vegas homes built after 2015 often has foil facing the wrong direction or a missing air space, which kills the radiant performance. Without a gap, the product conducts heat instead of reflecting it. We correct the orientation, restore the required air gap, and verify the assembly from the attic side.
  • Reflectix plus an unsealed attic floor is the combination we see most often on new construction, and the one that does the least. Reflective barriers only reflect what stays inside the attic; if the ceiling below is leaking conditioned air through can lights, top plates, and penetrations, the reflective barrier has no meaningful thermal envelope to work with. We seal first, then insulate.

Our Reflectix Attic Insulation Process

Professional performing attic insulation installation with loose-fill blowing machine
Our Reflectix Attic Insulation Process

Every Reflectix job in Las Vegas follows the same sequence, because the order is the whole result. Here’s what you get from the first call:

  1. 1
    Diagnostic visit. A named technician inspects the attic, measures existing insulation depth, documents the reflective barrier installation (orientation, air gap, seam condition), and runs a blower-door test – a pressurization reading that shows, in one number, how much air your building envelope is losing. You get the reading in writing.
  2. 2
    Written price and written scope. Before anyone lifts a tool, you receive a flat written price, a written scope listing exactly what’s being removed, corrected, or added, and a written warranty. That’s Haven Standard Clause 1. No verbal estimates, no day-of add-ons.
  3. 3
    Air sealing first. We seal top plates, recessed can lights (with rated covers, not foam), plumbing and wiring penetrations, and any gaps between attic and conditioned space. We will not blow insulation over an unsealed attic floor.
  4. 4
    Reflectix correction or replacement. Depending on what the diagnostic found: re-tension, re-orient, re-tape, or replace the reflective layer. We use foil-rated tape and correct fasteners, not whatever’s on hand.
  5. 5
    Insulation install. Blown-in fiberglass or cellulose to target R-value for a Las Vegas attic (R-38 to R-49 is typical for existing construction; new homes with radiant barriers can land lower). Baffles and ventilation prep included where needed.
  6. 6
    Post-install blower-door test and Documented Photo Record. We run the test again, publish before-and-after CFM50 numbers on the invoice, and hand you a photo record of the job. The 365-Day Done Right Promise applies: if it’s not done right, we make it right.

What Reflectix Attic Insulation Costs in Las Vegas

Most Reflectix attic insulation jobs in Las Vegas fall in these ranges. Your written price is the real number; these are what we typically see.

Scenario Typical Range
Attic insulation top-up with reflection barrier correction (1,500 sq ft) $2,400 – $3,900
Full removal of failed Reflectix + air sealing + new blown-in (1,500-2,000 sq ft) $4,200 – $6,800
Batt insulation install in a 2×4 rafter bay with Reflectix retained $1,800 – $3,400
Attic baffles and ventilation prep (with insulation job) $400 – $900
Blower-door test, pre and post (included in every job) Included

What moves the price: total attic square footage, whether the existing Reflectix can be corrected or needs removal, accessibility of the attic (some Las Vegas homes have very tight scuttles), and how much air sealing is required. A free second opinion on any written estimate is standard; bring us a competing quote and we’ll read it with you. Call (833) 362-4859 for a written price.

Why Las Vegas Homeowners Call Envelope Insulation Las Vegas for Reflectix Work

professional attic insulation service
Why Las Vegas Homeowners Call Envelope Insulation Las Vegas for Reflectix Work

Most Las Vegas attic insulation contractors will blow over an existing Reflectix install without checking whether it’s oriented correctly, taped at the seams, or sitting on the right face. That’s how the product ends up underperforming and taking the blame. Our technicians have up to 10 years of experience in building-envelope work, and they’re trained to read a reflective assembly before touching it. We’ve sealed and insulated over 9,000 homes since 2016, and every one ended with a written price in hand before work started and a documented record when the crew left. We also work with the rest of the market’s materials: Owens Corning, Johns Manville, Knauf, Rockwool, CertainTeed, Icynene, Demilec, and GreenFiber, so we’re not locked into one product on a Reflectix job. We work with the product line you have, and if it makes more sense to change direction, we’ll show you why. Calls are answered by a live person 24/7, and technicians are background-checked.

Get the price in writing before anything starts.A real person answers, day or night.
Call now

FAQs

Need Insulation help nationwide? Licensed & insured · 30-60 min response · free estimates
Call (833) 362-4859
Local Service Coverage

Request a Free Estimate in Las Vegas

Tell us what you need - Envelope Insulation Las Vegas responds fast. No obligation.

By submitting this form you agree to our Privacy Policy and consent to be contacted by phone, email or SMS about your request, including by local professionals who may handle it.

Prefer to text? Text Us
Call Now - 24/7 Dispatch